Hydra of Lerna Hueforge - Greek Mythology

If you print it, rate it. I put in the work. Rating helps me to keep doing that. I recommend using my print profiles for best results. They are setup and ready to print. Just select your filaments and the correct buildplate. I would also recommend reading below in full.  Send me a message if you have questions.

If you do not want to use an AMS, just delete the filament changes and replace them with pauses instead.

If you would like to sell my Hueforges a Commercial Licence Subscription is available. Do not sell my prints without it please.

Important:

1. You CANNOT adjust the Z axis scaling on a Hueforge. It will not come out as intended. You can change the X and Y values to scale the picture up or down though.
2. To ensure that the print looks the same as mine you must use the same filaments I did (listed below). If you do not, your results will not be exactly the same as shown. (It may still turn out great…..or it may not). 
3. What you see in the slicer will not accurately show the final result. Do not worry about this. Hueforge uses colour blending, but it does not show in the slicer.

You may see a floating regions error. This can be ignored.

Printing Instructions

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Remember to select the correct plate type for your printer.

I have used a height range modifier in the object settings for quicker printing. The layer swap numbers in the print profile will not match the ones written below. Do not worry about this.

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.1
PLA PolyTerra Army Blue Transmission Distance: 0.3
PLA Sunlu PLA+ Gray Transmission Distance: 2.5
PLA Esun PLA+ White Transmission Distance: 7.9
 

Swap Instructions:
Start with Black
At layer #10 (0.88mm) swap to Army Blue
At layer #14 (1.2mm) swap to Gray
At layer #19 (1.6mm) swap to White for the rest.
 

Ratings are welcomed.

Give me a follow.