Stable Hinge !upright printable! by Meister Edel

Meister Edel

Hobby & DIY>Other Hobby & DIY

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

Both Designs with good Settings. 2 Buildplates PLA

Designer

53 min

2 plates

4.9(22)

0.6mm nozzle, 0.3mm layer, 4 walls, 25% infill

56 min

2 plates

Open in Bambu Studio

Boost

166

348

273

Released

Description

This is a 3D Printable Hinge to be upright printable.

This way I can keep the tolerances small, the hinge is very stiff and stable. But the biggest advantage is that you can print lots of them at the same time!

Care not to tighten the screws too hard. That could weaken the hinge.

Comment & Rating (31)

@RaGo_awesome

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

Perfect result. Only the doodle on the back bothers me a little. Thought it is a print issue but its in the stl already

The designer has replied

@MeisterEdel

Soooory :D That design is older and I had a short period during which I put my logo on some designs 🤔

@plomdawg

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

turned an ikea drawer into a door with these

@ActionPaps

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

Schnell gedruckt und super funktioniert. Danke für die super Vorlage!

@sharah

Print Profile

0.2mm layer, 2 walls, 15% infill

flawless print in PLA, what a great model! the hinge loosens up easily right after printing, just fold it a few times. so cool!

@l.edlfurtner

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

lässt sich wunderbar drucken. Beim könnte man vermutlich sogar weglassen. einmal "freiknacken" und dann bewegt sich alles :)

The designer has replied

@MeisterEdel

So muss das :)

@tkunterwegs

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

Funktioniert super nachdem man es einmal gewaltsam bewegt hat

The designer has replied

@MeisterEdel

danke :) Viel Spaß damit!

@heyderekp

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

I couldn't get the hinges to print fully without them pulling off the plate, adding a brim resolved the issue!

@Smowens583

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

Printed both hinges and they turned out great. They're stiff at first, but after working them a few times they function great.

@bamaham93

Print Profile

Both Designs with good Settings. 2 Buildplates PLA

Worked very nicely for what I needed! Just be sure not to over tighten the countersunk screws; I broke one that way.

@heyderekp

Anyone else have issues printing this on the A1 and having the hinge pull off the plate and loose adhesion about 80% of the way done? (roughly most of the way through the 3rd screw hole? I've printed it twice, once with the exact print profile, and another adding a 10mm brim, same issue.