Vikings Lightbox
Copyright Claim
Vikings Lightbox
Boost
13
26
7
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
2.7 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
2.9 h
1 plate
Boost
13
26
7
0
37
47
Released
Description
Vikings lightbox. Vikings fans don't be upset with me over the purple we had to use, its what we had on hand that would transmit light through. If you have a darker purple that works well for lightboxes let us know.
Original example printed with Bambu basic PLA black, white, purple and gold (not silk gold).
Be sure to heat your hotend up to temp to clean any residual filament that may have been stuck to it from previous prints. This will help keep the color wisps down between layers so you'll have the cleanest print possible.
The back has a negative cube in it that you can move and scale to your needs for your light installation.
Enjoy and Happy Printing!
Comment & Rating (7)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Printed the cover, and it looks great. Finishing up the back cover.
Do you have a good light recommendation for using inside?
The designer has replied
0
Reply
These are the LED strips I use myself. I double loop the inside which comes out to be about 51 inches of the LED strip to get the two loops. Then I hotglue the led strip as a second adhesion to make sure they aren’t going anywhere, maybe not need since the tape on the back in pretty sticky but I do it anyways.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Turned out very nice. No changes needed.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld