This is Pandora, created using the amazing Hueforge.
Comes in two sizes and thin/thick to choose, the large one will take quite some time to print. On the photo you see the small version.
As usual with Hueforge, this will require 4 colours to change on specific layer height and will consume minimal filament.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
The thick model was created more recently with different colour combination and will take significantly longer to print.
Instructions (thick model - 5mm)
Filaments Used:
Swap Instructions:
Instructions (thin model - 2mm)
Filaments Used:
Swap Instructions: