This clip was designed by the Driving Simulation Laboratory at the Faculty of Computer Science of Schmalkalden University of Applied Sciences for integrating an original Logitech G Driving Force Shifter into a real Opel Corsa B. It is used to align and fix the y-axis potentiometer of the disassembled shifter in order to function correctly. Actually this alignment used to be done by the original enclosure which has been taken apart in our case. This design is shared just in case anybody is constructing their own custom enclosure.

Neither supports nor infill are required for this print but two or more perimeters and brim are recommended. PLA may be to brittle and might break on attachment. PETG is recommended.

Take care of the cables when attaching this clip! Don't damage them and ensure they point to the top as shown.