A Evil Minion on the front of the extruder that rolls one eye while printing.

Before you start printing, make sure you have a clean plate (Wash it in warm soapy water or IPA). The first layer has a lot of small elements that must stick well to the plate.

The printing profile includes two plates, one with standard fasteners and the secound with strong fasteners.
If you think that standard fasteners are too weak and may break, print a version with reinforced fasteners.

Let me know if the print was successful and if everything fits. If any corrections need to be made, let me know.

If you have printed it, please leave a rating.

Before installation, the original front and the rotating element must be dismantled.
During installation, the eye should be pressed as far as it will go. After putting the face, the eye should be flush with the face or deeper.
When assembling, make sure that the top latches are flush with the top edge before pressing from the front.
See my other projects.

Assembly instructions below. (same as Funy Face)

Version with strong top fasteners.