WW2 M42 Helm 1:1 by 7919alex

7919alex

Props & Cosplays>Masks & Helmets

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 2 walls, 10% infill

Designer

10.5 h

5 plates

3.7(3)

Open in Bambu Studio

Boost

Released

Description

Helm Model zweiter Weltkrieg, M42 Model

Fusion 360

Comment & Rating (7)

@kruizer29

this print is not very good it always come off plate and waste a lot of fillement

The designer has replied

@7919alex

I don't know what your problem is. I and seven others have managed to print this helmet Did you use my profile? Which printing plate are you using? Is it properly cleaned?

@kruizer29

I'm sorry for that I needed to put supports because it was to thin and when I did it worked but just a suggestion I would put in the definition to put supports and I printed it and it is a very good helm

@Eprints

Print Profile

0.2mm layer, 2 walls, 10% infill

all plates printed well except for plate 4. it continued to mess up with Petg and Pla. tried to clean the plate, nozzle, and reinserting the filament

The designer has replied

@7919alex

i have changed the settings a little bit and now should it work I am so sorry

@user_1344132965

Print Profile

0.2mm layer, 2 walls, 10% infill

@kruizer29

Print Profile

0.2mm layer, 2 walls, 10% infill

No more

License

This user content is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.