Hey Guys,

This is my creation for an Anti-Sag for my GPU.

Its Designed for Lian Li O11DX Dynamic and 36cm Cards(6900xt in my case).

maybe it will to other 3x120mm bottom-Fan designed Case and the Card-length should be around 33-36cm+ 2.5 slot Card (measure your height and scale)

there is 3-4mm Space for an rubber so its lays a little bit softer but not neccesary.

Why its so wide?

My Outtake-Fans a on the backside. and my Inlet-Fans are on the bottom.

The fan where the Anti sag is mounted blows fresh air directly to the outlet.

That was what i also was aiming for.

Printed with Bambu PETG with standart settings out of the Box.

No supports.

You will need 2x M5x12 Mounting Screws

and optinal an little piece of rubber.