Cat Ring
Copyright Claim
Cat Ring
Boost
43
68
10
Print Profile(1)
0.2mm layer, 4 walls, 12% infill
Designer
4.9 h
2 plates
Open in Bambu Studio
Boost
43
68
10
0
58
36
Released
Description
Wanted to make a toy for the cat, this uses a standard ping pong ball that the cat can knock around with its little paw.
The two pieces are held together by 8 magnets 4 on top and 4 on bottom, the size is 8x3. You can get an 80 pack on amazon for $10 US.
Comment & Rating (10)
All
Print Profile
0.2mm layer, 4 walls, 12% infill
love the two plate option, no supports needed
1
Reply
Print Profile
0.2mm layer, 4 walls, 12% infill
Printed without any issue, I have also printed a ping pong ball printed without issue. You can find the model here.
Ping pong ball:
https://makerworld.com/en/models/140112#profileId-152743
0
Reply
what did you do to connect the 2 pieces together
The designer has replied
0
Reply
There 4 magnets on top and 4 on bottom that hold the pieces together. The size is 8x3mm, I got an 80 pack off amazon for $10.
0
Reply
thank you! I just glued it together- I am unsure how it will hold up in the long run but thank you very much for the design.
0
Reply
cute!
0
Reply
Print Profile
0.2mm layer, 4 walls, 12% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 12% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 12% infill
Bed Adhesion Issue
0
Reply
Print Profile
0.2mm layer, 4 walls, 12% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld