Search models, users, collections, and posts
Window Stopper
IP Report
Print Profile(2)
TPU, 0.2mm layer
Designer
1.9 h
1 plate
0.2mm layer, 2 walls, 15% infill
53 min
1 plate
Open in Bambu Studio
Boost
61
211
25
5
300
214
Released
Description
The shape helps to keep the stopper in place, even if the window is moving due to wind. It can be used symmetrically.
I printed it in Armadillo TPU (https://ninjatek.com/shop/armadillo), a very hard TPU, but I think any material can be used.
To prevent damages on your window, while trying to close it with the stopper inside (this will happen sometimes at the beginning 😉), I recommend to print it in any kind of TPU.
It is 4cm wide at the thinnest point
UPDATE:
I made the outer wall a little bit thicker, so that when printed in TPU, it won't squeeze together but rather slide a little bit better up and down (hopefully)
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (25)