this was a simple print. If you want different sizes, just size it differently. But they fit great. IF you only plan on the legs alone, without like a grip on the bottom, then I would Place this one ABOVE your printer, unless you do stabalize it. I only printed the legs, but they printed all together in a bunch, had a decent amount for the legs to sit in, and added a good raise to the table ... JUST THE RIGHT AMOUNT for a Lack over a Bambu or V3. If you use an AMS LITE, then using larger PTFE tubes would be great, and put it above or below the printer. You could easily attach spool holders to the lack table as well. Great n simple supports.