Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
6.8 h
2 plates
Open in Bambu Studio
Boost
22
41
8
1
63
54
Released
Description
A Spiderman lightbox. Designed in Fusion 360. The main body is printed face down at a 0.2mm layer height and the back panel printed face up at 0.28mm height. I designed the back panel with 2 holes to enable wall hanging and 4 holes to screw to the main body (I have using glue!). I also added a small hole in the main body to add the USB wire that connects to the internal LEDS. I added the links to what I used below. The screws I use are 1/2" #5 wood screws, but you can use any other type of small screws.
USB Powered LED with Remote: Temu.com
Comment & Rating (8)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
l impression est très sympa,j ai eu quelque trou dans le design,c était visible à la lumière ,j ai du réparer a la colle et au feutre indélébile .
,peut être si la plaque avait été plus épaisse ,les trou aurai moi de chance d apparaitre.
les seul amélioration en plus de sa qui pourrai être bien serait un système pour fermer la boîte sans vis.
j ai vu un autre modèle de lampe spiderman qui se clipse sans vis juste avec les deux cote de la boîte.
il est pour mon petit cousin.il sera ravi.
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
several small areas, hard to remove every pinhole. very usable design. thanks!
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Prints Nicely
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Using the provided print profile, it printed with many visible gaps on the Spiderman image.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
model outlines are not connected. I printed twice with same issue. changed setting to detect thin walls that helped a bit but there are still a few areas of concern
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
Other Issues:Printed a couple of times with different settings, but the gaps between the outlines remained.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld