Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.7 h
1 plate
Open in Bambu Studio
Boost
47
102
10
0
124
45
Released
Description
flask with polygons
created in fusion 360
design inspired by traditional clay honey containers from the south of Portugal
photo shows print with:
- 0.16mm layer height
- 15% gyroid infill
- no brim or supports
printing in 0.16 instead of 0.20 increases print time by around 30 minutes, but in my opinion is worth it for the finer details in pattern and enhanced quality in the screw thread
If you enjoy using this 3D model and are able to, please consider supporting my work by buying me a coffee. Your contribution goes a long way in fueling future creations. Thank you for being a supporter!
note: all photos uploaded are of the actual printed model, taken inside a lightbox or in natural light on top of a desk / table
Comment & Rating (10)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Really cool and nice looking, will try in a water tight filament cause PETG water flow slowly through the walls
1
Reply
nice look, fits perfect, will try it in a water tight filament cause whit PETG water flows slowly out through the walls
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Orinted Perfect!
(Edited)
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Love the design and how well the lid fits the bottle!
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Cool model, overhang is a little steep and doesn't print great towards the end on the a1 at least
Other Issues
Support Issue
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
nice bottle mine leaks slightly but that’s probably form poor filament.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Other Issues
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld