Ikea Door screwless Handle/Knob for Platsa, Pax, Enhet, Kallax,... 16,5mm
Copyright Claim
Ikea Door screwless Handle/Knob for Platsa, Pax, Enhet, Kallax,... 16,5mm
Boost
12
25
8
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
28 min
1 plate
Boost
12
25
8
0
49
58
Released
Description
A door handle for all those IKEA doors (that are 16,5mm strong). It just clips on, no need screws.
It is 30mm wide. If you want a longer or shorter handle, you can just change the z-dimension in your slicer.
I printed mine with PETG
Comment & Rating (8)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Doesn't fit perfectly, the pax door is a bit wider. But for now, it's a fine temp solution, instead of the ducktape.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great fit on my Besta Cabinet. Printed in Clear PETG, expanded it to 60mm long to make it easy to use. I found it was a little easy to pull off so used a strip of doublesided tape on the door edge.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
nice! is perfect🙏🏿🙏🏿 thanks
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfect fit
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
ok
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Bed Adhesion Issue
The designer has replied
0
Reply
Try cleaning your print bed with soap-water or cleaning alcohol. If that doesn't help, you could try to activate a brim in your slicer.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld