拨杆光圈 mechanical iris 无需螺丝组装 no screws
Remixed by
Copyright Claim
拨杆光圈 mechanical iris 无需螺丝组装 no screws
Remixed by
Boost
74
170
20
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
2.4 h
4 plates
Boost
74
170
20
1
499
204
Released
Description
拨杆光圈，最大孔径80mm
无需螺丝，仅需3d打印组装
mechanical iris, maximum aperture 80mm
no screws, only 3d printing assembly
Assembly video：https://www.bilibili.com/video/BV1364y1K7jZ
notice：
That's why you need to print double the amount of leaves~
Comment & Rating (20)
All
Great model, but I can't get any further with assembling it at this point :(
The designer has replied
0
Reply
Hello, you need to insert the subsequent leaf under the first leaf and align it with the hole in the housing. The hole is now covered by the first leaf
0
Reply
thanks! great Model!
0
Reply
太棒了！看了你的视频买的碳纤维纹路的板 效果特别好！
卡扣那里悬空稍微有点松，我3M胶粘上了 一点不松了就
非常顺滑！
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Prints came out beautiful in silk PLA, now just need to make tons more of the fins!
The designer has replied
0
Reply
I hope you like it. I updated the assembly process in the introduction
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
A bit tricky to put together, but the final result was great and fun to play with!
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Its an pain to assemble don't print if you are in an hurry ):
0
Reply
Is it supposed to close all the way or just to a 1/2" opening.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
a little challenging to put together but very cool once assembled.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Bit fiddly, but works well. Elegant design, well optimized for 3d printing
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
The shutters are a bit too thin in my opinion. I had to print a few more than needed ^^ With the standard-PEI-printplate it's a pain to remove the shitters. After I switched to a flat surface H1H printplate everything went fine.
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld