ID Card Badge Holder
Copyright Claim
ID Card Badge Holder
Boost
8
17
4
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
8
17
4
0
36
32
Released
Description
Badge holder for ID cards. Slides in through top and lanyard loops through the card and holder. Cleanest print orientation is on its side with supports, but technically this does print successfully facing up with no supports, there will be strands of filament in some spots but the imperfections make the card fit in more snug if that matters to you.
Comment & Rating (4)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
sturdy design, printed great
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Vey solid id holder no issue with prints did have to rearrange position for better print on edges.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld