Marvel Line Wall Decor Hulk, Spiderman, Iron Man, Thor
Boost
94
178
16
Print Profile(2)
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
Designer
6.6 h
4 plates
BIGGER, one avatar splited into two parts with connectors 0.24mm layer, 3 walls, 5% infill
Designer
15.8 h
8 plates
Open in Bambu Studio
Boost
94
178
16
1
175
112
Released
Description
Wall decor inspired by Marvel Universe. Thor, Iron Man, Spider Man and Hulk.
There is two print profiles
- one frame splited and added connector to have bigger size of poster
- one frame on one plate.
Comment & Rating (16)
All
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
gefällt mir gut, ich brauch aber noch weitere 😁 Venom zb (:
1
Reply
Print Profile
BIGGER, one avatar splited into two parts with connectors 0.24mm layer, 3 walls, 5% infill
Prints super good but connectors are really tight and need a lot of force to slide into each other. Not breaking it is a challenge. Also, orientation is off... Printed both spider man parts of the big one and during assembly I recognized different surfaces due to different print orientation (one is printed "face" on buildplate and one is printed "back" on buildplate), so I had to flip at least one of the parts and print again to have a harmonized surface. Same with Thor.
(Edited)
0
Reply
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
looks great, would love a few more :)
0
Reply
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
printed nice
0
Reply
Print Profile
BIGGER, one avatar splited into two parts with connectors 0.24mm layer, 3 walls, 5% infill
Muito Bom :)
0
Reply
hey, i like it really , but i need more ^^
please add other Characters also ;)
thanks!
best regards,
Christian
0
Reply
Where is the captain ?
0
Reply
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
geil!
0
Reply
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
0
Reply
Print Profile
SMALL - One Avatar per plate, 0.24mm layer, 3 walls, 5% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld