Non Raised Nozzle Wiper Remixed by eier1188

Remixed by

eier1188

3D Printer>3D Printer Accessories

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

PETG 0.12mm layer, 3 walls, 15% infill

Designer

32 min

1 plate

4.9(19)

Open in Bambu Studio

Boost

155

111

Released

Description

I modified the nozzle wiper made by @jocin_: https://makerworld.com/en/models/94607#profileId-101194

I modified it so the new wiper gets installed above the stock wiper so it does not raise the stock wiper.

Unscrew the existing stock wiper, Slide the printed part onto the existing wiper. Screw the new part where the existing wiper was screwd into in the poop chute. Then cut and glue the little a1 nozzle wiper part onto the other printed part, and screw it on. VERY detailed instructions can be found on the original makers page, download Jocin_'s model to support him too: https://makerworld.com/en/models/94607#profileId-101194

If you like it then check out my other models and download them for support, Thank you.

Also Coffee: https://www.buymeacoffee.com/eier

Thanks!

Comment & Rating (21)

@MemelMagic

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

all good.

@stino

Boosted

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

don’t mind the tall thing. :D

@PCHuDSoN

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

did move the wiper down and did the same sort of job as the stock one. however doesn’t work that well for me as means purge also makes it’s way on to the bed, much like that stock one. thanks anyway

@Maoirae

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

prints ok

(Edited)

@Jimsy

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

used the non-raised base, but used the brush holder from th original that prevents it from swiveling.

@hitcha

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

Printed very well :)

@raskal

Print Profile

PETG 0.12mm layer, 3 walls, 15% infill

Nicely printed will try it soon

@stino

Boosted

Works perfectly with the a1 brush tray from jocin !

@tcarlson7771

Tried it, seemed to work fine at first but during a print resume during a job, it consistently failed to remove purged filament string. Gave a boost though as a lot of effort went into this remix