A weird little tea light/light cover I designed. Can be scaled as needed. Recommend using an LED tea light or light strip to illuminate. 100% and 200% are shown in the images.
printed on at 100% and one at 150%.
they do look super nice.
although I would suggest adding a brim or mouse ears. had a few problems with the print stick8ng to the bed
It's a very nice looking print. I had some trouble on the interior where it narrows, there was a bit of separation, almost stringing. I tried it on both my X1C and the A1 with two different brands of PLA filament. Same errors in the same spots. Probably something that can be tweaked by those that are in the know, but I couldn't get it to work well enough to gift it to a friend.
Is this what you're talking about? The photo on the left is scaled at 100%. The issue seems to resolve in the photo on the right, which is scaled to 150%. Perhaps a workaround to your issue? Would love for you to be able to gift to a friend. Let me know if it helps. May be worth a shot as it still uses minimal filament even at 150%.