The Hat Shaper
The Hat Shaper
Boost
31
35
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
59 min
1 plate
Boost
31
35
15
0
55
98
Released
Description
Here is a simple hat bill shaper.
Two different curves
One straight slot to make it flat again.
You can use a steamer to steam the hat to help keep the form longer.
If you print it, please rate it and post a picture.
Thank you.
Comment & Rating (15)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
beautiful perfectly fits my hat now my I can make my hat have the perfect curve and flatness
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Gave the perfect bend!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
scale up and it’s perfect
(Edited)The designer has replied
0
Reply
must have a large hat! its designed to slide about an inch on the beak. works for me.
0
Reply
Replying to @TheMumbl3r
its actually too small for my hats. I scaled it up and it works
(Edited)1
Reply
Replying to @1jessedamofo
I've noticed a few people have said the same. thank you for the info. I'll scale it larger.
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Easy, wont fit all my hat brims.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld