I designed this laptop stand because I was looking for something that could hold three school computers, and charge them at the same time. These computers are bulky because of the case that the school puts on them so they should fit almost all laptops and Chromebooks. The connector pieces are designed to have a grove that runs along the bottom of them to fit a charging cable and route it to the front for easy access. I have only tested the print profile designed for three computers, but they all should work the same. I tested on Overture PLA White with the included print profile. Assembly is pretty self-explanatory from the picture, you do have to squeeze the thin parts on the connectors together a little bit to get them to fit in the hole. Hope you enjoy it and that this helps you out.
Comment & Rating (6)