Oversized, hexagonal deck box designed for commander. Compatible with both double and triple sleeved decks.

I printed this at 0.16mm on the X1C with a textured plate.

There are some magnet spots at layers 657 on the Body (given 0.16mm per layer and 0.2mm initial layer), and layer 29 on the lid. I used some from K&J magnetics I got a while ago, and they are about 6.5mmx13mm and 2-3mm in depth.

Don't forget to add supports like I did on the face cover. It allows a Hard Sleeve to be fitted in great, but without supports there is no good bridge point for the printer as well as a small section that its bridging to stand alone until it happens.

Feel free to download, remix it, whatever. Just be wary, its a large print, takes a few hours, and if you aren't careful you could end up with a fault like mine.