Custom Lightsaber Assembly (No glue, No Supports)

Introduction

This is a no-glue-required build. The parts are threaded to make for easy assembly. Perfect as a gift or to make a fine addition to your collection.

Parts list
1x Pommel
1x Hexacore Diatium Power Cells
3x Palladium Vortex Rings
1x Power Casing
1x Leather Wrap
1x Midgrip
1x Cycling Energy Fields
1x Kyber Crystal
1x Magnetic Stabilization Ring
1x Emitter
1x Emitter Shroud
1x Activation Input
1x Giftbox (optional) fits a prusament box
 

Assembly
Important note: Do not screw too tightly or risk popping the screw off the part.
Note: nothing is needed other than the printed parts.

1. Screw the Pommel and the Hexacore Diatium Power Cells together.
2. Place the three Palladium Vortex Rings on the shaft of the Hexacore Diatium Power Cells.
3. Screw the Power Casing to the Pommel
4. Slide the Leather Wrap onto the Power Casing.
5. Screw the Midgrip onto the Power Casing.
6. Push the Kyber Crystal into the Cycling Energy Field. 
7. Friction fit the Magnetic Stabilization Ring onto the Cycling Energy Field.
8. Screw the Cycling Energy Field into the Midgrip.
9. Place the Emitter loosely into the Emitter Shroud.
10. Screw the Emitter onto the Magnetic Stabilization Ring.
11. Screw the Shroud onto the Magnetic Stabilization Ring.
12. Press the Activation Input onto the Midgrip.

Now you are ready to become a Jedi Master.