This AirTag holder Design requires a few parts for assembly that I will list below. Best printed at 0.1mm layer height as its quite small and requires a nice curve around the AirTag. PETG or ASA is best if you are going to use it outdoors.
Comes in an open top design to show off an AirTag engraving or closed top for full protection.
Insert nuts are fairly easy to put in the print, soldering iron only needs to be around 100C and these press in fairly easily.
I have supplied ready sliced Gcode for MK3 and Mini that stops at the correct Layer to insert the 4 magnets.
Requires:
Optional Mounting Accessories:
If you struggle to source the parts or don't have a 3D printer you can buy a MultiTag from my Etsy store
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.