Parkside Battery Holder for X20V
Remixed by
Copyright Claim
Parkside Battery Holder for X20V
Remixed by
Boost
5
7
8
Print Profile(2)
0.28mm layer, 2 walls, 15% infill
Designer
33 min
1 plate
Stronger & more Infill around the Screw holes
Designer
36 min
1 plate
Open in Bambu Studio
Boost
5
7
8
0
24
19
Released
Description
This is a remix of the Drill Battery Holder Parkside from GameFan.
I removed the bottom because it was unnecessary. I also adjusted the top to the angle of the Parkside batteries so that it now fits 100 percent precisely. Print upright without support. Because it is a functional piece that doesn't have to win a beauty contest, I chose a layer height of 0.28
Comment & Rating (8)
All
Perfect fit and screw holes where they should be.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Bed Adhesion Issue:leider mit PETG sehr starkes Warping.
The designer has replied
0
Reply
Moin, ich habe das Modell auch mit PETG gedruckt und überhaupt kein Warping.
Haben Sie mit geschlossener Tür und Abdeckung gedruckt? Das Bett gut gereinigt vorher? Anscheined stimmt die Druckbetthaftung nicht, aber das kann man nicht über das Profil steuern.
0
Reply
Print Profile
Stronger & more Infill around the Screw holes
alles super
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Très bien
0
Reply
Print Profile
Stronger & more Infill around the Screw holes
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld