Astromech Droid.
Copyright Claim
Astromech Droid.
Boost
380
613
24
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
72.3 h
7 plates
0.2mm layer, 2 walls, 15% infill
Designer
91.6 h
6 plates
0.2mm layer, 2 walls, 15% infill
Designer
73.4 h
6 plates
Open in Bambu Studio
Boost
380
613
24
9
658
213
Released
Description
Old files from a Site, just dusted them off. Will be posting more files of this in different colors schema for the bambu.
The Radar eye is in the Raw Files as it is black in color.
Documentation (1)
Assembly Guide (1)
astromech assembly guide_20cc64b7-a3c1-4b23-b4e2-0471e2c751af.pdf
Comment & Rating (24)
All
Do you happen to have instructions on how it all gets put together or know where i can find them?
The designer has replied
1
Reply
its actually very simple and very easy to asemble. sorry just seeing this. 3mm screws is what i use with nuts m3*10 m3*12 and m3*25 are the screws i use. i will say the feet you will need to trim some off the leg bottom to get them to slide in properly. use an excato knife carefully and shave both sides off a little. m3*25 through the batter and then the leg to the foot.
0
Reply
Replying to @Get3don
Simple is not quite what I would say :) the screws helps a lot but how does the center pieces / retraction thing for the front wheel assemble?
0
Reply
Replying to @AniMeiGrrl
added on the profile
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Overall, solid but flaws. One acknowledged but not fixed is the fit of the feet to the legs. Also, the center foot does not quite come down t the surface.
The designer has replied
0
Reply
The outter legs yes that was a Design flaw. i find if you scrap a tad off the insert where the screw is at with a Knife it works okay. the Center Leg comes down only when he is Kicked back. not standing idle upright,
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
every plate printed well. there are a few assembly issues of tolerance but are easily fixable with hand tools.
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
@danspctx Is it just me or is the "radar eye" missing? Maybe I'm overlooking it...
(Edited)The designer has replied
0
Reply
yes and no, It's not in the Bambu 3mf file. it's in the Raw files.
0
Reply
Greetings, Would this print be 1/6th scale perchance?
The designer has replied
0
Reply
its closer to 1/4 scale.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
good print
0
Reply
Very cool. I'm building a full-sized astromech and would love to have a matching 3D printed companion. Would definitely love to have the "standard" color scheme and will follow to watch for it. Thanks! ;-)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld