Room Fountain

A small indoor fountain, a beautiful decoration among flowers and plants, or for humidification

The parts are simply plugged together. See assembly instructions below

If you want hydroponic plants in the fountain, I have added suitable grid baskets to the second print profile

Additionally, only a small water pump is needed, such as this one: https://www.amazon.de/dp/B09Z2NS9YF?psc=1&ref=ppx_yo2ov_dt_b_product_details

and a short piece of soft hose with an inner diameter of 13mm and approx 40 mm length

Alternatively, I have also added a print profile for a hose piece made of TPU

The basin has sufficient wall thickness so that it is watertight when printed with proper calibration

(flow calibration of the material is important so that the layers are properly connected)

Assembly instructions:

• The small adapter piece of the pump is connected to the hose and the pipe piece and then inserted into the pump

• The pump is inserted into the base part, the cable is guided out through the slot

• Then the pitcher is placed over the base part

  

• Now the upper pipe piece with flange can be inserted into the pitcher from above. The upper pipe is pushed into the lower pipe section
• finally, the lid is placed on the spout so that the water does not splash upwards

The pump should be throttled as much as possible, otherwise the water jet is too strong

Feel free to check out my other fountain as well:

© Staprin3D