Happy Little Pill Organiser
Copyright Claim
Happy Little Pill Organiser
Boost
40
66
11
Print Profile(3)
0.2mm layer, 3 walls, 15% infill
Designer
43 min
2 plates
Single plate, two colours, AMS, all printers, 0.2mm layer, 3 walls, 15% infill
48 min
1 plate
Two plates (separate top & base), all printers, 0.2mm layer, 3 walls, 15% infill
58 min
2 plates
Open in Bambu Studio
Boost
40
66
11
0
113
103
Released
Description
Happy Little Pill
Small Pill Organiser. Ideal to be stored in your bag to hold all your pills !
Comment & Rating (11)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Took me a few minutes to clean up the supports but it locks great!
The designer has replied
1
Reply
yeah supports can be a little tricky to remove ! looks great :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
beatiful
The designer has replied
1
Reply
Thank you :)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Spot on profile, i had no issues with this, print came out lovely.
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
didn't connect at all
The designer has replied
0
Reply
the tolerances can be quite tight, have you checked to see if all support material was removed ? I know on a few I printed, even a small bit of support material still left on the model caused it not to connect.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
Single plate, two colours, AMS, all printers, 0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld