TETR_S - just another balance tetris game? NO!

Just another Balance Tetris Games... Yes! But:

•  The game is played with a dice, which chooses the brick you have to balance.
•  There is a straight 4-block brick.
•  The balance base has been improved so that you can also start with the straight 4-block brick.
•  The balance base has been perfected so that the game doesn't take forever, but rather becomes increasingly difficult the higher you go.

•  A toothed section has been added between the balance base and the ground base to ensure everything stays in place during play.

   

Attention! A new version (V2) has been released!

• Improved rolling behavior between base and ground! (Friction between the gears > -50%)
• Easier insertion of the letters into the base (larger letters, better fit, easier to glue)
• Easier insertion of the parts into the cube (Better fit, easier to glue, thicker and therefore less fiddling)
• Elimination of the tiny triangles to mark the center (gluing these in was always a task in itself)

The V1 profiles have been removed. If you need them for reprinting, send me a short chat message.

How to Play:

• Place the base centered on the ground.
• Roll the dice an place the shown brick an the base.
• The next person takes a turn, rolls the dice and places the shown brick at base (playable by two to four players).
• Continue in order.
• If the tower falls (or only one brick falls down) the game is lost.
• If the diced stone is no longer available, any stone can be placed.
• Have fun!

The 4 stones of each color are completely sufficient, there is no need to print more.

Are you looking for a storage box?
Try the TETR_S storage box [official #3 of 3] or the previous released 

TETR_S storage box [official #1 of 2] or TETR_S storage box [official #2 of 2]

Or are you looking for a new challenge in the next dimension?
Try TETRΔS - The new dimension TETR_S

Have you seen TETR_S Go - The best balance game in travel size ?

A MakerWorld user just pointed out to me that profiles are circulating where the number of game pieces has been changed, meaning the entire game no longer fits in one of the storage boxes!

To ensure all pieces fit together and the gaming experience isn't compromised, please only use the print profiles from @fuxx (marked with “designer”!

I can't do anything about modified print profiles either.

The settings all have a reason:
- The dice must be balanced, meaning the sides must be exactly as thick as the bottom and top layers.
- The infill must be this value so that the weight of the dice is correct and it rolls smoothly.
- The weight of the individual pieces must be this value so that the tower doesn't tip over too early and the game doesn't become unplayable due to the high difficulty.
- The layer height of 0.21 mm isn't just a value; it's precisely adjusted to the line width and, above all, the beveled corners.
- ...

How to glue:

The game instructions are now available in more languages!

Take a look to the documentation section.

I would need your help for all other languages: The translations.zip file contains an Excel file with all the text blocks. Please add your preferred language to it and send back the file via chat. Thank you!

I frequently receive inquiries about printing problems with various print profiles created by other Makerworld users.

Unfortunately, I have no control over the profiles that other Makerworld users upload to my models (Neither the geometry nor the print settings). 

While these are often well-intentioned, they are not maintained, and the results are sometimes unsatisfactory.

Therefore, I strongly recommend using only the print profiles marked "Designer". I can only provide support for these!