Fire Dragon - Hueforge
Fire Dragon - Hueforge
Boost
42
76
17
Print Profile(1)
0.08mm layer, 1 walls, 100% infill
Designer
3.9 h
1 plate
Boost
42
76
17
0
128
61
Released
Description
This is a small Hueforge Picture of a Fire Dragon for good luck in 2024.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 4
Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Red
At layer #14 (1.2mm) swap to Yellow
At layer #24 (2mm) swap to Jade White for the rest.
Comment & Rating (17)
All
Print Profile
0.08mm layer, 1 walls, 100% infill
красиво
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
beau resultat
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
very beautiful
(Edited)
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
love the detail and color was expecting more orange though
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
Super!
(Edited)1
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
schönes Design aber sehr dünn gedruckt
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
Super thin but otherwise ok.
0
Reply
I'm new to this
did my Bambu slicer do it automatically
if I use the AMS ? thanks
aricklee88@hotmail.com
0
Reply
Print Profile
0.08mm layer, 1 walls, 100% infill
why is there a brim with a 1mm gap? otherwise printed ok in abs.
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld