Dice Book
Remixed by
Copyright Claim
Dice Book
Remixed by
Boost
55
111
8
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.8 h
1 plate
0.2mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
55
111
8
7
83
37
Released
Description
No magnets:
With magnets:
Print in place. No supports required. I recommend PLA and 0.2 layer height.
For the magnet version: Use 5x1mm with the thin cover, 6x3mm with the thick cover.
UPDATE: You can print the magnet version in two parts now. Just glue the two parts together. I wanted to put a design on the cover and I think this makes it a lot easier to print.
Comment & Rating (8)
All
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print and profile, thanks for sharing! Love customizing the cover. What a cool little print! A little felt to prevent dice rattling would be a great addition if you make one.
II found to get the latch to really hold well and without worrying about it popping open, you can put some CA glue onto the cover half of the latch and let it dry (without closing it obviously!), then gently sand away some to get a snug fit on the tab. If you can, try the magnet version and see which you prefer.
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
so cool! going to be great for dnd
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works great, no need for magnets as the clip holds it firm.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld