Bowens Mount Adapter for Godox Speedlight Softbox

Copyright Claim

Bowens Mount Adapter for Godox Speedlight Softbox

Boost
3
9
2

Print Profile(1)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

PLA with breakaway support, 0.28mm layer, 6 walls, 25% infill
PLA with breakaway support, 0.28mm layer, 6 walls, 25% infill
Designer
1.4 h
1 plate
4.0(1)

Boost
3
9
2
0
26
8
Released

Description

The portable flash softbox produced by Godox is designed to be fixed upon the edge of the Godox S-mount. In order to install it on standard Bowens mount LEDs, I designed this adapter based on the outer rim of the S-mount. The size of the Bowens mount is measured from the standard reflector on hand.

 

The test version shown above was printed using Bambu PLA Basic, set to 6 wall layers and 25% triangle infill. The strength is good so far (although, like other Bowens mount accessories, it is a bit loose). I recommend using a matte black high-strength material, such as PLA-CF.

 

Support needs to be generated at the bottom of the three claws. The uploaded print file already has support surfaces drawn for manually generating tree-like supports. I strongly recommend multicolor printing using breakways support filament. With around 0.8g of support filament usage and 4 filament changes, you can obtain a clean finish :D

 

This model is licensed under CC BY-NC-SA 4.0. Commercial usage is forbidden.

 

-----

 

神牛出品的便携闪光灯柔光箱在设计上仅能用神牛 S 卡盘的边缘进行固定。为了将其安装到标准保荣接口的灯具上,我参考 S 卡盘的外形设计了这个转换件。保荣接口本身的尺寸测量自手头的标准罩。

 

封面图上的测试版本使用 Bambu PLA Basic 打印,设定为 6 层墙以及 25% 三角形填充,目前强度良好(但跟其他保荣口附件一样比较松)。我更推荐使用哑光黑色的高强度材料,例如 PLA-CF。

 

在支撑方面,模型需要在三个盘爪底面生成支撑,上传的打印文件中已经绘制好了用于手动生成树状支撑的支撑面。我强烈推荐使用易剥离支撑进行多色打印,仅需约 0.8g 的支撑面用量和 4 次换料,就能得到很干净的表面 : D

 

本模型依据 CC BY-NC-SA 4.0 开源,禁止商业使用。

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Print Profile
PLA with breakaway support, 0.28mm layer, 6 walls, 25% infill
The designer has replied
0
Reply
Could you please tell me what is going wrong? Your feedback would be invaluable in guiding my improvement efforts : )
0
Reply
No more