Search models, users, collections, and posts
Asus 65w PSU mount for Multiboard & Underware
Remixed by
IP Report
Print Profile(2)
0.2mm layer, 3 walls, 15% infill
Designer
1.3 h
1 plate
Offset version - 0.2mm layer, 3 walls, 15% infill
Designer
1.3 h
1 plate
Open in Bambu Studio
Boost
22
77
11
6
144
83
Released
Description
It is a remix of already perfect mount for the Asus 65W PSU to be used with Multiboard or Underware.
I would suggest printing in PETG, with PSU going warm PLA might deform, but if you print in PLA then please share your experiences.
The angled plug comes out a little further at the edge. There is an extra flattening in the bracket for this.
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (11)