Ford Maverick Cubby Flex Anchor (FITS and Blank slate provided) by im.jackharvest

im.jackharvest

Hobby & DIY>Vehicles

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

1.4 h

1 plate

Open in Bambu Studio

Boost

Released

Description

The video really needs to be seen to do this justice. The way this works is pretty difficult to describe by words.

Essentially, a wedge is created under a minor amount of pressure between the top-rear corner, and the front-lower ridge that the rubber pad provides.
After using a few of the printed creations here, and seeing that many (of not all, really) relied on the use of velcro, or sticky tape to keep the inserted box in place, I set off to resolve the issue once and for all.
It even prints ALMOST without the need for supports; I recommend turning it on; It's merely for the lip on the lower front to print proper. Every else prints straight up without any support needs. It's pretty sweet!

(Creative commons license NON COMMERCIAL. You MAY take this model, and add, modify, etc, provide Remix links etc and re-upload here on Thingiverse for free. You may NOT use this model to create something to sell on Etsy, or other online locations. That right is reserved. Sorry.)

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Supports:

Yes

Resolution:

.20

Infill:

15-20%

Filament:COEX PLA (PETG might be best for long term resiliance) Inferno Orange

Notes:

Supports only needed for the tiny, tiny, TINY lip at the very bottom. The entire inverted FITS slot does not require supports due to the 45 degree angle when printed on the circle's back.

Category: Automotive

Comment & Rating (4)

@user_1253156852

I made one, and a FITS to go in it, and I designed a "finger" to fit the ring on the back of my phone. It almost worked, but it is not secure. The probem is the notch at the bottom. It should be oriented more in line with the bottom, and not rotated 45°. It should also be wider.