Stackable Storage Drawer - Deep

Stackable Drawer system that is compatible with the Steintrack system. The drawer is made to perfectly fit a 35mm bin, and this version is DEEEEEEP.

The tolerances on the drawer is fairly forgiving, however if your printer does have some settings issues you will find the drawer is a bit rough to pull out. I had no issues with my X1, but less than ideal outcome on my temperamental Kobra Max.

If you have any issues or feedback, please feel free to reach out and let me know.

The 35mm bins can be acquired here. Label is included in the bin files.

All profiles I've uploaded include four versions of the drawers:

No Label
Front Label 
Handle Label 
Double Label

I have also included a riser per request that gives a 1.5 inch opening below it, raising it a total of…. 1.5 inches plus 6mm. Someone do the math on that and put it in the comments. 

NEW: I've created feet that can snap into the top to hold stuff! 

(Yes I copy pasted this from the old drawer. I'm lazy. Thank you for noticing) 

PS. For the Full Size drawer, the top doesn't fit on the plate on the X1C due to the exclusion zone. Due to this I cut it in half in the profile, the Steintrack SteinTtie Clips work fine to reconnect it, they can be found here. If you want to print it in one piece you can adjust the exclusion zone to "0x0, 14x0, 14x28, 0x28" and adjust the support First Layer Expansion to 0mm. I have included the full size plate in the profile in case you want to do this. Just please print it slow as you may overshoot and trigger the filament cutter if you're not careful.