YOU ROCK - Trophy
YOU ROCK - Trophy
Boost
97
127
7
Print Profile(1)
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
1.9 h
1 plate
Boost
97
127
7
1
108
93
Released
Description
I colored the pupils with a pen.
Settings:
- 0.20mm Standard
+custom settings: - Wall loops: min. 2
- Infill 30 %
- supports are not necessary
Comment & Rating (7)
All
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
Smaller parts need brim as they fall off otherwise (using textured plate). Also, the hole in the rock does not match the pin in the stand, so had to use pliers and some glue :D very cool idea though!
0
Reply
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
hole on the rock isn’t big enough, but ended up cutting the piece off the base and glueing the rock on.
0
Reply
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
It appears they fixed the issue with the base orientation. I was successful in printing it with the orientation but not with this profile hence the new rating
(Edited)The designer has replied
0
Reply
idk why the program changed the orientation after I printed it but I fixed the file
0
Reply
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
Cool little print, but the hole on the bottom of the Rock isn't big enough, you have to do some modifying for it to connect.
1
Reply
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
(Edited)
0
Reply
Print Profile
Print By Object 0.2mm layer, 2 walls, 15% infill Gyroid
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld