X1C Angled Hygrometer Mount
Copyright Claim
X1C Angled Hygrometer Mount
Boost
17
31
24
Print Profile(1)
0.2mm layer, 3 walls, 15% infill w/ snug supports
Designer
38 min
1 plate
Open in Bambu Studio
Boost
17
31
24
0
99
77
Released
Description
This is a mount/stand for a generic 40mm circular hygrometer / thermometer that sits at the back of the enclosure.
I liked what papsjundi did with his hygrometer mount but had a hard time reading the display through the front glass since it's angled upward to view it through the top glass. So I made mine vertical and angled it toward the camera and added deeper plugs for extra security. I recommend printing it in PETG. 0.2 layer height, 3 walls, at least 5 top/bottom layers, & 15% infill. There's a little supports needed, but put the top z distance at 0.24 and it pops off easily.
Link to buy the hygrometers:
https://www.amazon.com/gp/product/B0885TFLZX/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&th=1
Comment & Rating (24)
All
Too close to the belt in the back and smaller nub is rounded!! See the pic. it can't go in
The designer has replied
1
Reply
Good to know, it's not like that on my X1C or P1P
0
Reply
it’s a P1s
0
Reply
Replying to @Purr_geandPrint
Yeah, I figured. The belt on my X1C is about 6 or so millimeters away from the back of the mount too. Sorry I didn't work as expected on your P1S.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
Ich habe einen 4 Wochen alten x1c und das gleiche Problem mit dem kleinen Loch,
Scheinbar hat Bambu das Bauteil der Drucker geändert.
Aber macht nichts, ich habe eine kleine Säge angesetzt, siehe Bild.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
It does its job very well.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
Perfect and in view of the camera, i did not have black petg so i printed it in black ABS came out great. Thanks!
0
Reply
very good. a bit close to the belt in the back and i had to snip off t he smaller nub since it wasnt going down in that specific hole in chassis. thanks for making this.
The designer has replied
0
Reply
Yeah, it's very close to that back belt. One of the pegs didn't want to fit into the hole? The big or small one?
0
Reply
the small one. thanks.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
Had to trim small peg down to 6mm to sit flat in my P1S. Does clear the belt and visible from camera and door
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
works great 👍
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill w/ snug supports
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld