ONI Mask by Grafo3D

Grafo3D

Props & Cosplays>Masks & Helmets

IP Report

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

H2D

0.2mm layer, 2 walls, 15% infill

Designer

5.5 h

1 plate

5.0(13)

Open in Bambu Studio

Boost

285

489

262

131

Released

Description

Oni mask, check the measurements and adjust them to your liking

oni mask

demons

japan

Comment & Rating (20)

@zviryatko

Print Profile

0.2mm layer, 2 walls, 15% infill

For A1 mini difficult to make it bigger, so not for wearing, but as wall mask is looking good, gonna send it to some friend.

@apocolypse410

Try Tinkercad I resized a different mask and it work maybe that will work for you.

@zviryatko

Replying to @apocolypse410 :

Ah, thanks, I have basic 3d skills and can enlarge it, the problem is that I have a1 mini with the plate size ~18x18cm and inner section should be at least 16-17 to wear it comfortably (measured my face), in that case need to make side walls thinner, also area for nose looks small. And because of a1 mini again I need to turn model into some weird angle to fit large size... So model is good, the hard part to print it bigger in small area :)

@Dario84

Replying to @zviryatko :

Hi. I have also an A1 mini. If you resize the mask and then rotate it 45 degrees it should feet on the bed.

@SwageBlock

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

This is an awesome mask!

@user_1662052515

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Great file. thanks for sharing.

@kyleolsondesign

Printed with CCTree's Ebony Wood PLA

@asthordrag

Print Profile

0.2mm layer, 2 walls, 15% infill

looks fine

@breazcbdi

Print Profile

0.2mm layer, 2 walls, 15% infill

@Kingsten08

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

The mask adapts well to the face when the sides, left and right, are heated on the print bed until they are slightly pliable A beautiful design and a very good print profile

Show original