Skadis Cable Holder
Remixed by
Skadis Cable Holder
Remixed by
Boost
4
12
3
Print Profile(2)
PETG 0.2mm layer, 3 walls, 50% infill
Designer
18 min
1 plate
PLA 0.2mm layer, 3 walls, 50% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
4
12
3
1
16
18
Released
Description
A cable holder for skadis pegboards. The hook can`t slip out of the board.
Diameter of the cable hole is 5 mm, so the cable can glide through it, but not the plug
I designed a second holder (PLA). At some pla filaments the hook broke when the cable was assambled. That should not happen there.
Comment & Rating (3)
All
Print Profile
PETG 0.2mm layer, 3 walls, 50% infill
Worked as intended
0
Reply
Print Profile
PETG 0.2mm layer, 3 walls, 50% infill
0
Reply
Print Profile
PETG 0.2mm layer, 3 walls, 50% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld