Ultimate Defense Knuckles
Copyright Claim
Ultimate Defense Knuckles
Boost
81
120
30
Print Profile(1)
0.2mm layer, 3 walls, 60% infill - Added Supports
1.8 h
1 plate
Open in Bambu Studio
Boost
81
120
30
4
208
204
Released
Description
I Designed these for fun, they are very strong when printed with 50% infill or higher. They will tear through drywall without any issues. They are sharp, and will hurt.
Comment & Rating (30)
All
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
have yet to test it out but have high hopes!
1
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
looks dangerous
1
Reply
Boosted
Great for self-defense. Very durable when using my 60% infill, 3-wall print profile.
The designer has replied
0
Reply
Thank you for printing and rating!
1
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
Started printing very well but then started to warp and failed about halfway thru the print. Going to try again and add a Brim to see if it helps with warping. also going to raise the bed temp by a few degrees. Great file otherwise 👍
0
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
Other Issues:The bottom side was pretty rough in the finger holes and spikes
0
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
0
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
really good kinda had to get my brother stitches though 😁
1
Reply
Boosted
Super stabil
0
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
A little big for me
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 60% infill - Added Supports
came out very good
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld