Steam Deck OLED Charger Holder

Copyright Claim

Steam Deck OLED Charger Holder

Boost
91
189
57

Print Profile(2)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

no ams
no ams
Designer
2.5 h
1 plate
4.8(17)

With Ams 2 color
With Ams 2 color
Designer
3.1 h
1 plate
4.7(13)

Boost
91
189
57
5
290
221
Released

Description

Here's a support for the Steam Deck Oled. Suitable for a 2.5-meter long cable. The version I've included comes with tree supports and colored writing. I've set a 0.3 z-offset between the support and the print to facilitate detachment. Alternatively, you can decrease the z-offset on the upper support for a better finish. There are two versions, one with AMS and one without AMS. The choice is yours. If you like it, like and comment. Happy printing!

Comment & Rating (57)

Please fill in your opinion
(0/5000)

Print Profile
no ams
works well
The designer has replied
2
Reply
thank you
0
Reply
Print Profile
no ams
fits great. Supports are good to remove
The designer has replied
1
Reply
thank you
0
Reply
Print Profile
no ams
Does the job
0
Reply
It fits the US plug perfectly, thanks for sharing!
0
Reply
Printing it now. First time auto printing something from the app with supports.
The designer has replied
1
Reply
Fantastic . I hope you like it
0
Reply
Replying to @jonathan.albori :
top is pretty. underside not so much. just not sure if that’s more support stuff to take off. or if the supports took a layer with them.
0
Reply
Replying to @Shadraak :
between that it is normal you could greatly improve the final result below if you use PETG supports. with AMS you set the support with petg and the gap between support and print to 0
1
Reply
Print Profile
no ams
The designer has replied
0
Reply
will this work with us plug?
The designer has replied
1
Reply
no sorry
0
Reply
US plug works
1
Reply
Print Profile
no ams
Support removal is a little bit annoying, but it worth it.
The designer has replied
1
Reply
hi, Is only way i found to the 2,5 m size of thise cable. but i'm Happy work . thank you !
(Edited)
0
Reply
question. is this still support stuff? or did the supports take away a few layers? if it took away I guess I’ll have some sanding to do this weekend.
0
Reply
Print Profile
no ams
it fits even for regular (non-OLED) steam deck case :)
2
Reply
Print Profile
no ams
Worked out pretty good! but the support was pretty difficult to remove
The designer has replied
1
Reply
Hi, yes, unfortunately I haven't found an effective way for the type of geometry of the project to easily remove the supports. I should draw the object differently to be able to use fewer supports. thanks for feedback
(Edited)
0
Reply