Hellraiser Hue Forge

All of the pictures displayed are of the actual models. Please take a moment to rate and endorse the models, as it is very helpful.

Hellraiser HueForge

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 128.4x170mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.2mm and the Actual Depth is 2.1mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Red Transmission Distance: 4
    PLA BambuLab Basic BambuLab Green Transmission Distance: 2
    PLA BambuLab Matte Marine Blue Transmission Distance: 0.5
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 6 unique filaments

Swap Instructions:
    Start with Black
    At layer #7 (0.64mm) swap to Red
    At layer #10 (0.88mm) swap to BambuLab Green
    At layer #11 (0.96mm) swap to Marine Blue
    At layer #14 (1.2mm) swap to Blue
    At layer #16 (1.36mm) swap to Jade White

Border Only Colors from here until the end.
    At layer #24 (2mm) swap to Black for the rest.