The Handler - File Handle by user_3846318659

user_3846318659

Tools>Hand Tools

IP Report

Print Profile(1)

All

P1S

P1P

X1 Carbon

A1 mini

H2D

0.28mm layer, 3 walls, 20% infill

Designer

1.1 h

1 plate

4.6(12)

Open in Bambu Studio

Boost

162

377

146

Released

Description

A handle for files with a shank between 2.8-4mm in diameter

The parts should be printed in a material like PETG, ABS or ASA.

Do not use PLA, as it is prone to cracking and warps over time if under pressure!

Comment & Rating (12)

@user_3013541971

Print Profile

0.28mm layer, 3 walls, 20% infill

Printed on a P1S in Tecbears PETG, for safety I set the brim to "outer only 5mm". The model is exquisite and a joy to behold! The grip is also sufficient, and the file is held very securely. However, the thread is a little too tight. A bit of PTFE spray will improve it. Thank you for sharing!

Show original

@Kakri76

Print Profile

0.28mm layer, 3 walls, 20% infill

Thank you!

@user_614293300

Print Profile

0.28mm layer, 3 walls, 20% infill

user_3846318659...good print...threads are a little tight👍

@romikxp

Print Profile

0.28mm layer, 3 walls, 20% infill

@HariboSnackbox

Print Profile

0.28mm layer, 3 walls, 20% infill

Its very tight fit, needs postprocessing to work properly.

@AiGeneration

Print Profile

0.28mm layer, 3 walls, 20% infill

Nice design even with PLA . If you could make a same version with rougher grip/handle - anti-slip . !

@user_786689259

Print Profile

0.28mm layer, 3 walls, 20% infill

u guys. make me do it. I try to give everyone a 5 star rating because I simply luv 3d printing. I understand there r some problems but it's a learning process & part of the fun. thank you very much