This is a charging stand for the Google Pixel Watch 2.
Edit: Added a v2 which features much less open space at the bottom of the ring and made the ring flush with the stand. This version is a bit of a tighter squeeze, so I'll be leaving the original available as well.
Printed with supports for the main body, I also used a raft for better bed adhesion although this is almost certainly unnecessary.
Assembly is straight forward:
- String the cable through the main body via the charger opening
- Slide the inner ring around the charger
- This is directional and is intended to have the inner channel facing towards the front, this ensures that the charger is inline/proud of the face to make charging easier.
- If you have issues getting the watch to attach to the charger, pop the ring out and reverse it.
- Press the charger firmly into the main body,
- this is a press fit to ensure the ring doesn't move but should slide relatively easily
- Pull the charging cable taunt along the channel on the bottom of the stand and slide on the bottom panel.
Removing the charger assembly can be done easily with a flathead screwdriver through the bottom opening after removing the bottom plate.
Printer Settings:
- Ender 3v2 Sprite (Direct Drive Extruder)
- Filament: eSUN ePLA-Lite
- Slicer: Cura
- Supports: Yes (Main body only)
- Bed Adhesion: Raft
- Layer Height: 0.28mm
- Initial Layer Height: 0.2mm
- Bed Temp: 60C
- Infill: 18%
- Pattern: Cubic Subdivision
- Print Speed: 85 mm/s
- Print Cooling Enabled