statue of liberty model
statue of liberty model
Boost
38
84
15
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
1.9 h
1 plate
Open in Bambu Studio
Boost
38
84
15
0
211
107
Released
Description
statue of liberty, i can do any buildings too just ask
Comment & Rating (15)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Very nice model. Printer X1C, Bambu white marble PLA.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
gratis design
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Failed at every turn but most likely was my fault and lack of knowledge and setting, beautiful model though!
The designer has replied
0
Reply
sorry for the failure m8, there was loads of positive builds. same as me sometimes I can't print some things. it's frustrating
0
Reply
I just printed it off again, it's black I couldn't be brothered to change the filment lol. but it is printable just on stock settings I painted a few supports on 1 under the arm and 1 under the torch
0
Reply
Replying to @Fatalchaos25
Definitely I just wish you could rate higher than 3 without a print. Cause as I said extremely beautiful.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
love it its jus vey delicate
The designer has replied
0
Reply
post a photo of it
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Strength Issue
The designer has replied
0
Reply
sorry maybe I should have used more infill
0
Reply
it may have been I needed better supports. I'll try again and give a better rating when I get it to work.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Support Issue
0
Reply
No more
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld