+++ free of charge for a short time +++

You probably know the problem: The keys are attached to the key ring with simple metal rings - and then suddenly - one of these rings keeps coming off the key ring. In the worst case scenario, the key is now lost.

It happened to me all the time.

So I thought about it: A key ring that is much easier to open than those stupid, fiddly metal rings. Nevertheless, it should be securely locked and impossible to open unintentionally.

This is how the EasyKey was created.

The ring is simply turned 3 steps to the left to clear the opening. It's super easy to insert the key - without hurting your fingernails - and turn the ring 3 times to the right over the detents. That's it!

(After 3 stages of opening or closing, there is a limit stop)

Created various combination options for the design:

EasyKey 1x with additional fastening eyelet

EasyKey 1x without eyelet

1x rotatable ring as narrow version (medium rotatable; low pressure tolerance)

1x rotatable ring as thick version (moderately difficult to rotate; low pressure tolerance)

1x rotatable ring as a narrow version and easy to rotate (greater pressure tolerance)

1x rotatable ring as thick version and easily rotatable (larger pressure tolerance)

The ash screw fits both versions.

Just try out which ring fits best with your printer. Printing really only takes a few minutes.

Support is already integrated here. This means you don't have to select the support settings yourself. Simply print and remove Support and Brim super easily.

Assembly: Screw the axle screw completely into the ring. Remove the support from the housing.

Now clip the complete ring into the housing.

!!! Please note the position in which the ring is clipped in!!! See photos and video! Clipping in requires more force. It has to be this way, otherwise you would lose the ring - including the key.

The whole thing may have to be moved a few times, then it should be easier.

No more unhinged keys. From now on :)

https://youtu.be/yGUdsrR2v48

https://youtu.be/1wUhxt0bodQ

3D PRINTING SETTINGS

Material: PLA (tested with PLA)

First layer: 0.2mm

Layerheight: 0,2mm

no support