Small Hook for HSW (honeycomb storage wall)
Remixed by
Copyright Claim
Small Hook for HSW (honeycomb storage wall)
Remixed by
Boost
25
68
11
Print Profile(2)
4up | 0.2mm layer, 3 walls, 20% infill
Designer
59 min
2 plates
Single hook | 0.2mm layer, 3 walls, 20% infill
Designer
16 min
1 plate
Open in Bambu Studio
Boost
25
68
11
0
102
84
Released
Description
I made a small hook for the HSW (smaller than others that I've seen). Works well with the plastic scrappers.
Comment & Rating (11)
All
Print Profile
Single hook | 0.2mm layer, 3 walls, 20% infill
used it to hold my hex walls to a glass partition in my cubicle
The designer has replied
0
Reply
Thanks for the feedback. Happy to hear that you were able to make use of it.
If you plan to put any significant weight on it, you may want to look at these stronger ones: https://makerworld.com/en/models/233455
I'd say go for the 10mm one, but use the "tight" HSW insert
0
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
Good Work.
thx
0
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
1
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
1
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
1
Reply
Print Profile
Single hook | 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
Single hook | 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
0
Reply
Print Profile
4up | 0.2mm layer, 3 walls, 20% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRemixes (2)
Related Models
© 2024 MakerWorld