This time I bring you one of the evil ones from Dragon Ball "Freezer".
In this print I have used 4 colors, but you can use 3 if you want to eliminate for example the gray or one of the two purple colors.
The purple layer is thin and you get a good result if you want to put a rear light on.

Happy new year!!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA PolyLite Pro Dark Purple Transmission Distance: 0.3
PLA PolyLite Pro Metallic Magenta Transmission Distance: 1
PLA Protopasta Silver Smoke Grey Transmission Distance: 20
PLA PolyLite Pro White Transmission Distance: 5

Swap Instructions:
Start with Dark Purple
At layer #9 (0.8mm) swap to Metallic Magenta
At layer #17 (1.44mm) swap to Silver Smoke Grey
At layer #29 (2.4mm) swap to White for the rest.