Articulated Cute Bunny
Copyright Claim
Articulated Cute Bunny
Boost
97
130
14
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
3.4 h
1 plate
Open in Bambu Studio
Boost
97
130
14
3
162
107
Released
Description
Cute Bunny I modeled using Blender 4.0!
Printing Multiples Will Optimize Filament Usage!
View My Other Work Here! → https://www.etsy.com/shop/Waffly3D?ref=l2-about-shopname
Comment & Rating (14)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
so cute
The designer has replied
2
Reply
2 Animals are ALWAYS cuter than 1
(Edited)2
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Tiny but cute
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
So süß, auch im Dunkeln...
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
There was a print error if you fill the bed. Had to delete some. Also ran into an issue with the AMS where it kept erroring out about 30% in. Not blaming the creator as I believe these are more issues with the firmware. I recommend printing in low quantities.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Support Issue
The designer has replied
1
Reply
Sorry about that, I'm guessing it was the ears that failed, possibly lowering the print speed (at least around the ears) could fix your issue..
(Edited)1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Share AlikeRelated Models
© 2024 MakerWorld