Phone Stand
Copyright Claim
Phone Stand
Boost
220
298
150
Print Profile(4)
Normal - 0.16mm layer, 2 walls, 100% infill
Designer
1 h
1 plate
0.2mm layer, 2 walls, 100% infill
1.1 h
1 plate
0.2mm layer, 2 walls, 15% infill
1 h
1 plate
0.2mm layer, 4 walls, 75% infill
48 min
1 plate
Boost
220
298
150
4
1.2 k
1.1 k
Released
Description
NOTE: It is highly recommended to print the model with my print settings.
Presenting a sleek, minimalist 3D-printable phone stand with a fixed tilt angle. Crafted from scratch, this design draws inspiration from various models while being meticulously engineered from the ground up. Ideal for any smartphone, this stand combines functionality with a modern aesthetic, offering a stylish solution for hands-free viewing.
Comment & Rating (150)
All
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
I dont think the Brim was nessesary, and its annoying to remove.
otherwise it's good
(Edited)
The designer has replied
0
Reply
you can easily remove by yourself from the slicer if you don’t need it. it’s a precaution for nooby users that don’t know how to clean a pei plate.
(Edited)1
Reply
Replying to @franceschelli
I added the star, you're basically right, I just printed it from my phone while on the go and then got confused at home.
(Edited)1
Reply
Replying to @Poldion
thanks 🙏
0
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
Printed Fuzzy! Very good!
2
Reply
Your Phone Stand looks perfect :-)) Unfortunately my print has a small fault. How could I prevent that? Thanks in advance!
The designer has replied
1
Reply
maybe you should try to slow the external print speed.. but I’m not sure
1
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
perfection
The designer has replied
1
Reply
thanks
0
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
Parfait merci beaucoup🙏🏻
2
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
Printed great using PETG
The designer has replied
1
Reply
thanks
0
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
The profile worked great.
The designer has replied
1
Reply
thanks 🙏
0
Reply
Turned out well. Transparent Yellow PETG. Nice design. Thank You!
The designer has replied
1
Reply
thanks!
0
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
Awesome low profile phone stand that also doesn't cover the bottom of the screen.
The designer has replied
1
Reply
look nice 😊
0
Reply
Print Profile
Normal - 0.16mm layer, 2 walls, 100% infill
using this for my old ipad wich it can support from tbe side. upwars is possible but the angle could cause it too fall backwards
(Edited)
1
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld